3. Resin Pressed Flower Crystals

Resin is where I slow down and get strict before pouring. I work with the window open for ventilation, wear a respirator and gloves, and mix epoxy exactly to the manufacturer’s ratios, because guessing leaves a piece tacky. On my bag it stayed glossy, smooth-edged, and never caught the lining. Heavier than the others, it rides on a bag, and I give epoxy the full cure time.

Things Needed

  • Clear epoxy resin or UV resin
  • Miniature silicone molds (rectangles, circles, or hexagon shapes)
  • Miniature dried, pressed flowers and greenery
  • Fine tweezers and wooden stirring sticks
  • A UV lamp (if using UV resin) or a dust-free curing area (for epoxy)
  • A handheld lighter or heat gun (to remove bubbles)

How to Make

  1. Prepare the First Layer: Mix your epoxy resin precisely according to the manufacturer’s instructions, or ready your UV resin bottle. Pour a thin, transparent layer into the bottom of your silicone mold.
  2. Pop the Bubbles: Pass a heat gun or a lighter quickly over the surface of the liquid resin to pop any micro-bubbles from mixing or pouring. Keep the heat moving and your hands clear.
  3. Arrange the Florals: Use fine tweezers to pick up the dried flowers and place them face-down in the liquid resin layer, arranging a pleasing composition. Press gently so no air pockets stay trapped beneath the petals.
  4. Seal and Pour: Pour a second layer of clear resin over the flowers until the silicone mold is completely filled. Use your heat gun one final time to ensure total clarity.
  5. Cure and Unmold: For UV resin, place the mold under a UV lamp for 2 to 4 minutes. For epoxy resin, let it sit undisturbed in a dust-free environment for 24 to 48 hours. Once hardened, pop the charm out and connect hardware through the pre-cast hole.